Jeep Cherokee (XJ): Front carpet/mat. Rear carpet/mat. Rearview mirror
REMOVAL (1) Remove the door sill inner scuff plates.
(2) Remove the front and rear seats (as applicable).
(3) Remove floor console.
(4) As necessary, remove the trim panels and
moldings.
(5) Remove all other interfering components.
(6) Remove the carpet and mat from the floor
panel (Fig. 78). INSTALLATION (1) Position the carpet and mat on the floor panel.
1 - CARPET AND MAT (2) Install all the components that were removed
to facilitate carpet/mat removal.
(3) Install the trim panels and moldings.
(4) Install the door sill inner scuff plates.
(5) Install floor console.
(6) Install the front and rear seats (as applicable). REMOVAL (1) Remove the liftgate latch striker and scuff
plate.
(2) Drill-out the retaining rivet heads and remove
the cargo tie-down footman loops from the carpet.
(3) As necessary, remove the trim panels and
moldings.
(4) Remove the all other interfering components.
(5) Remove the carpet and mat from the floor
panel.
(6) If necessary, remove the insulation from the
wheelhouse (Fig. 79). INSTALLATION (1) If removed, install the insulation on the wheelhouses.
(2) Position the mat on the floor panel.
(3) Position the carpet on the mat.
(4) Install all the components that were removed
to facilitate carpet and mat removal.
(5) Install the trim panels and moldings.
(6) Install the cargo tie-down footman loops on the
carpet with replacement rivets.
(7) Install the liftgate scuff plate and latch striker.
1 - REAR WHEELHOUSE REMOVAL (1) Loosen the mirror base setscrew (Fig. 80).
(2) Slide the mirror base upward and off the
bracket.
1 - MIRROR INSTALLATION (1) Position the mirror base at the bracket and
slide it downward onto the support bracket.
(2) Tighten setscrew to1 N·m (9 in. lbs.) torque.Front carpet/mat
Fig. 78 Front Carpet and Mat
2 - POWER SEAT WIRE HARNESS SLOT
3 - FLOOR PANEL
4 - SEAT FRAME STUDRear carpet/mat
Fig. 79 Wheelhouse Insulation
2 - FACE SIDE
3 - ADHESIVE
4 - WHEELHOUSE PANEL
5 - FACE SIDE
6 - ADHESIVE
7 - WHEELHOUSE PANEL
8 - LOWER INSULATION
9 - UPPER INSULATIONRearview mirror
Fig. 80 Rearview Mirror
2 - SUPPORT BUTTON
Front shoulder belt/buckle. Rear shoulder/lap belt/buckle. Full floor console
Rearview mirror support bracket. Sunvisors. Headliner
Other materials:
Front door hinge. Front door restraint. Front door outside handle
Front door hinge
REMOVAL
(1) Remove door restraint (check) retaining pin.
(2) Remove door hinge bolts and shims (Fig. 26).
(3) Retain door hinge shims for correct installation.
INSTALLATION
(1) Position hinge plates and shims on door face.
Fig. 26 Front Door Hinge
1 - UPPER HINGE
2 - ...