Jeep Cherokee (KL): To Set A Desired ACC Speed. To Cancel. To Turn Off

Jeep Cherokee (KL) 2014 - 2023 Owners Manual > Understanding the features of your vehicle > Adaptive cruise control (acc) > To Set A Desired ACC Speed. To Cancel. To Turn Off

To Set A Desired ACC Speed

When the vehicle reaches the speed desired, push the SET + button or the SET - button and release. The EVIC/DID will display the set speed.

If the system is Set when the vehicle speed is below 20 mph (32 km/h), the Set Speed shall be defaulted to 20 mph (32 km/h). If the system is Set when the vehicle speed is above 20 mph (32 km/h), the Set Speed shall be the current speed of the vehicle.

NOTE: ACC cannot be set if there is a stationary vehicle in front of your vehicle in close proximity.

Remove your foot from the accelerator pedal. If you do not, the vehicle may continue to accelerate beyond the set speed. If this occurs:

  • The message "DRIVER OVERRIDE" will display in the EVIC/DID.
  • The system will not be controlling the distance between your vehicle and the vehicle ahead. The vehicle speed will only be determined by the position of the accelerator pedal.

To Cancel

The following conditions cancel the system:

  • The brake pedal is applied.
  • The CANCEL button is pushed.
  • An Anti-Lock Brake System (ABS) event occurs.
  • The shift lever/gear selector is removed from the Drive position.
  • The Electronic Stability Control/Traction Control System (ESC/TCS) activates.
  • The vehicle parking brake is applied.
  • Driver seatbelt is unbuckled at low speeds.
  • Driver door is opened at low speeds.
  • A Trailer Sway Control (TSC) event occurs.
  • The driver switches ESC to full-off mode.

To Turn Off

The system will turn off and clear the set speed in memory if:

  • The Adaptive Cruise Control (ACC) ON/OFF button is pushed.
  • The Normal (Fixed Speed) Electronic Speed Control ON/OFF button is pushed.
  • The ignition is turned OFF.
  • You switch to Four-Wheel Drive Low.

    Previous pageAdaptive Cruise Control (ACC) Operation. Activating Adaptive Cruise Control (ACC). To Activate/Deactivate

    Adaptive Cruise Control (ACC) Operation The speed control buttons (located on the right side of the steering wheel) operates the ACC system. Adaptive Cruise Control Buttons 1 - NORMAL (FIXED SP ...

    Next pageTo Resume. To Vary The Speed Setting. Setting The Following Distance In ACC

    To Resume If there is a set speed in memory push the RES (resume) button and then remove your foot from the accelerator pedal. The EVIC/DID will display the last set speed. NOTE: If your vehicl ...

    Other materials:

    Lamp bulb service
    REMOVAL AND INSTALLATIONHeadlamp bulb REMOVAL (1) Remove the screws attaching the bezel to the grille opening panel (Fig. 1). (2) Remove screws attaching the retaining ring to the headlamp canister. (3) Disconnect the headlamp bulb wire harness connector. (4) Separate the sealed beam fr ...